Focal FDP 4.600V2 4-channel car amplifier — 150 watts RMS x 4
High-powered, full-range, and will work with almost any system
Focal's FDP 4.600V2 4-channel amplifier can deliver 150 watts RMS to each of your front and rear speakers, ideal for a high-performance system. You can also use the amp in 3-channel mode, powering each of your front speakers with 150 watts RMS, while sending 400 watts to a sub. The FDP 4.600V2 uses full-range Class D technology to deliver big-league power from a chassis that's smaller than a fresh pack of printer paper.
The amp's speaker-level inputs and auto turn-on let you connect it to almost any car stereo, even a factory radio. You can use the extensive filter section to optimize the amp's tone and performance for your subwoofers or speakers. In bandpass mode, the amp can even drive woofers, tweeters, and other components separately.
Remote control and clip light
Focal includes a wired remote bass level controller for your sub, so you can tweak your bass from song to song from your front seat. This remote also features an LED clip light that'll let you know if you're overloading the amp.
Product highlights:
- 4-channel car amplifier
- 150 watts RMS x 4 at 4 ohms
- 200 watts RMS x 4 at 2 ohms
- 400 watts RMS x 2 bridged at 4 ohms
- CTA compliant
- full-range Class D amp technology (frequency response: 5-25,000 Hz)
- Ch 1 and 2: variable high-pass filter (50-4000 Hz, 12dB/octave)
- Ch 3 and 4: variable high-pass and low-pass filters (50-4000 Hz, 12dB/octave)
- Ch 3 and 4: bandpass filter option (uses low-pass and high-pass settings) and stereo/mono switch
Other Features:
- remote subwoofer level control with LED clip light included
- preamp and speaker-level inputs
- speaker-level inputs require speaker wire to RCA adapters
- signal-detection turn-on with speaker-level input
- wiring and hardware not included with amplifier
- 8-gauge power and ground leads recommended
- fuse rating: 25A x 2
- dimensions: 10-1/16"W x 2"H x 8"D
What's in the box:
Focal FDP 4.600V2 owner's manual
- 4-Channel amplifier
- Two 25A ATO fuses (internally installed)
- Long mounting bracket
- 2 Short mounting brackets
- Remote sub control
- 16.5' Remote cable (RJ-25 plugs on each end)
- 3 Allen wrenches (2mm/2.5mm/3mm)
- Four 8mm counter-sunk screws
- Four 1" screws
- Two 3/8" screws
- 4 Rubber flat-washers
- Operation manual
Have a question?
Focal FDP 4.600V2 4-channel car amplifier — 150 watts RMS x 4